Sheartak Spiral Cutterhead for WOODMASTER 718 Planer

Description

Spiral Cutterhead for WOODMASTER 18” Planer with 120 Carbide Knives
Woodworkers are now retrofitting spiral cutterheads to their old planers, jointers for the following advantages.
*
Smoother Finish with no tear-out. Each knife sits at a slight angle and produces shear-cut . Spiral cutterhead planes board in staggered cut which is much better than single
straight
cut. The combined shear and staggered cut eliminates tear-out and leaves a glassy surface finish on even highly figured hardwood.
*
Noise is dramatically reduced as spiral cutterhead allows a few knives to cut in a staggered way.
*
More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges.
*
Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, tighten the insert in minutes. It cuts your production time by 30%.
*
Dust extraction is easier. Spiral cutterhead produces thinner and shorter chips.
*
Low cost to use. Spiral cutterheads produce a smoother finish, reduce or eliminate sanding work, don't require sharpening, your products will pay for itself in a very short time.
Kit include:
120 carbide inserts
5 inserts and 5 screws as spare parts
1 Torx wrench
Free shipping to USA and Canada